The completion of the firmware update in time 1 is not confirmed.ġ. The following table shows the possible status conditions. Wait until the firmware update is complete. If the progress window appears, the firmware is currently updating. Update Firmware window from the newly opened If the message displays, use the following corrective action: might appear when you log on to the maintenance utility. In the following screen, click the top option and then clickĭo not terminate the application forcibly while it is running otherwise, the message On the SVP, create a new folder, and then copy all the files from the SVP software media into the new folder.Īllow access. On the console PC connected to the physical SVP or running the SVP software, insert the SVP software media.
NoteThe upgrade time can take up to 9 hours to complete when NAS modules are installed. Procedures are provided for upgrading the SVP software only, or installing the SVP software,ĭevice Manager - Storage Navigator, and storage system firmware at the same time.
The following instructions describe how to upgrade the SVP software. If you disabled the Hi-Track Remote Monitoring System, enable it (see Not selected as a firmware upgrade target. Update Firmware window and review the error details. Software components are upgraded individually. The following table shows the possible status conditions: Run update window opens and the software update starts automatically. When the target storage systems list window opens, select the appropriate storage systems, and then click Wait for the preparation to complete and for the target storage systems list window to open. In the following screen, click the top option, as shown, and then clickĮnvironmental Settings window opens as the system prepares for the upgrade.
Next, accept the license agreement, and clickĪllow access. On the SVP, create a new folder, and then copy all of the files from the SVP software media into the new folder. You can enable Hi-Track after you upgrade the SVP software.Īt the console PC connected to the physical SVP or running the SVP software, insert the SVP software media. ) otherwise, the upgrade procedure will fail. Disable the Hi-Track Remote Monitoring System (see.The following procedure describes how to upgrade the SVP software,ĭevice Manager - Storage Navigator, and storage system firmware.īefore downgrading the SVP software, contact the Upgrading the storage management, SVP software, and storage system firmware.This procedure can be used with storage systems that have firmware version 83-01-21 or later. This procedure describes how to upgrade the SVP software, without upgrading the storage management software and storage system firmware. After the software is upgraded, you can restart the service. You must stop the service to upgrade the SVP software. Stopping the service in each storage system.You can enable Hi-Track after you upgrade the SVP software using Storage Device List. Disable the Hi-Track Remote Monitoring System.For details about backing up your SVP configuration, see